Set-Up Mount & Power On - Car and Driver INTELLIDASH PRO DU1000 Manual De Usuario

Step One
Insert the adhesive suction cup mount into the bracket on the
back of the INTELLIDASH PRO and slide it up to lock it in place.
Step Two
Remove the protective film from the adhesive suction cup on the
bottom of the mount. Then press the suction cup onto your dash-
board and push the lock down to secure it in place. Adjust the
INTELLIDASH PRO's angle and height so that it does not block
your view of the road, and tighten the knob to secure it in place.
Set-Up Mount & Power On
Lock
Open
Lock
Closed
Tighten
Knob
5
EN