Ingersoll Rand 2705P1 Especificaciones Del Producto página 2

Adjustments
Setting the Power Regulator
Impact wrenches are not torque control
devices. Fasteners with specific torque
requirements must be checked with suitable
torque measuring devices after installation
with an impact wrench.
Model 2705P1 Impactool incorporates a power
regulator into the reverse mechanism that
allows the operator to have either full power
output in one direction and reduced power
output in the other direction or full power
output in both directions. To adjust the power,
proceed as follows:
For full power in both directions, rotate the
reverse valve until the notch on each end of the
reverse valve aligns with the number 5 on each
side of the housing.
The numbers 0 thru 5 on the
housing are only for reference
and DO NOT denote a specific
power output. Zero (0)
designates the lowest power
output while five (5) denotes
the highest.
For reduced power in the forward direction
and full power in the reverse direction, push
Specifications
See table on page 10.
Save These Instructions. Do not destroy.
When the life of the tool has expired, it is recommended that the tool be disassembled,
degreased and parts be separated by material so that they can be recycled.
Refer to PXXXX-3 for Parts and Maintenance.
Tool repair and maintenance should ony be carried out by an Authorized Service Center.
2
the reverse valve inward on the right side of the
tool and rotate the reverse valve until the notch
on the right side aligns with the desired number
on the right side. This provides reduced power
in forward but full power in reverse when the
reverse valve is pushed in the opposite
direction. See Dwg. TPD1248.
(Dwg. TPD1248)
For reduced power in the reverse direction
and full power in the forward direction, push
the reverse valve inward on the left side of the
tool and rotate the reverse valve until the notch
on the left side aligns with the desired number
on the left side. This provides full power in
forward but reduced power in reverse when the
reverse valve is pushed the opposite direction.
See Dwg. TPD1249.
Dwg. TPD1247
(Dwg. TPD1249)
PXXXX-2 Ed 1