STORING UNIT
SHORT TERM (1-6 MONTHS):
1. Add gasoline conditioner & stabilizer at the specified
concentration.
2. Run the unit for two (2) minutes to ensure the mixed fuel
is in the entire fuel system. Close the fuel valve and run
the unit until it stops.
3. Remove the spark plug, pour 1-2 teaspoons (5-10cc)
of engine oil into the cylinder, slowly pull the starter
handle 2 or 3 times, reinstall the spark plug and tighten
securely.
4. Clean the exterior surface of the unit and apply a rust
inhibitor.
5. Store the unit in a dry, well ventilated place.
LONG TERM (MORE THAN 6 MONTHS):
1. Add gasoline conditioner & stabilizer at the specified
concentration.
2. Run the unit until the fuel tank and carburetor are dry.
As the engine is beginning to die, move the choke lever
to the choke position.
NOTE: Turn off the idle control to decrease the run time.
3. Remove the spark plug, pour 1-2 teaspoons (5-10cc)
of engine oil into the cylinder, slowly pull the starter
handle 2 or 3 times, reinstall the spark plug and tighten
securely.
4. Clean the exterior surface of the unit and apply a rust
inhibitor.
5. Store the unit in a dry, well ventilated place.
WARNING: FUEL SHOULD BE DRAINED IN A
WELL VENTILATED AREA AND STORED IN A
CONTAINER APPROVED FOR GASOLINE.
36
Storage
Service
Operator's Manual