Yardgard 3283ADJ48 Instrucciones Para La Instalación

YARD GARD
WARNING: CONTAINS LEAD. May be harmful if eaten or chewed. May generate dust containing lead. Wash hands after use. Keep out of reach of children.
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov
Please read all instructions before proceeding. Always wear protective eye wear when assembling.
Tools needed: Adjustable Wrench, Pliers, Wire Cutters, Hacksaw, Screwdriver or Nut Driver
Items contained in this kit:
Item # Qty Description
1 2 Gate Frames, Vertical
2 2 Gate Frames, Horizontal
3 2 Tension Bars
4 1 Roll of Chain Link Fabric
5 6 Gate Clips, 3283ADJ48
5 8 Gate Clips, 3283ADJ60
5 10 Gate Clips, 3283ADJ72
6 4 Self-Tapping Screws
7 1 Truss Wire Corner Hook
Truss Wire
8 1
Truss Wire Clamp
9 1
10 10 Tie Wires
11 2 Frame Hinges
Fork Latch Kit
12 1
Turnbuckle
13 1
NOTE: Gate Posts and Post Hinges are not included in this kit
and must be purchased separately.
NOTE: The final width of the gate frame will be 4" narrower
than the gate opening as measured from the inside of the gate
posts. 2" on each side is required to accommodate for hinges
and fork latch. For drive gate configuration two adjustable
gate kits are required. The final gate configuration will be 6"
narrower than the gate opening. 2" is required on each side and
2" between the gates for drive gate configuration.
Step 1:
FOR SINGLE GATE CONFIGURATION: If the gate posts are not already in-
stalled, then set the gate posts in cement at maximum distance of 72"
as measured from the inside distance between the posts (Figure 1). If
the gate posts are already installed, measure opening dimension, from
the inside of the posts. The distance must be less than or equal to 72".
FOR DRIVE GATE CONFIGURATION: If a drive gate is being installed,
two adjustable gate kits are required. If the gate posts are not already
installed, then set the gate posts in cement at maximum distance of
142" as measured from the inside distance between the posts
(Figure 1). If the gate posts are already installed, measure the opening
dimension, from the inside of the posts. The distance must be less than
or equal to 142".
®
3283ADJ48, 3283ADJ60 and 3283ADJ72 Adjustable Gate Kits
Gate Post
Post Hinge
Post Hinge
Step 2:
Once the distance between the gate posts is determined, use the
Reference Chart to determine the width of the horizontal gate frames.
Be sure to use the Reference Chart with your gate model number and
height. If the opening is 72", the horizontal gate frames do not need to
be cut. If the opening is smaller than 72", the horizontal gate frames
will need to be cut to the designated length.
4' Model: 3283ADJ48 Reference Chart
Gate Opening Horizontal Gate Frame Length
72" No Cutting Needed
64" Cut to 38" long
60" Cut to 34" long
54" Cut to 28" long
48" Cut to 22" long
42" Cut to 16" long
36" Cut to 10" long
30" Cut to 4" long
Minimum gate opening for 3283ADJ48 is 30"
For gate openings not represented by the tables, add 1" of horizontal gate
frames length for each additional inch of gate opening. For example, if the
gate opening is 38", cut each horizontal gate frame to 12".
Adjustable Gate Installation Instructions for:
Figure 1
Gate Post
72"
Final Gate Dimension
68" wide
60" wide
56" wide
50" wide
44" wide
38" wide
32" wide
26" wide
Page: 1 of 4