SAFETY INSTRUCTIONS
The sun lounger and its parts are made of aluminium in combination with
textile material. Sunbeds are exposed to environmental influences such as
large temperature fluctuations, humidity and intense sunlight. To ensure that
you enjoy your sun lounger for as long as possible, you should observe the
following instructions:
•
Avoid prolonged contact with moisture and standing water. Take your
furniture indoors when it rains or cover it with a protective cover. After
short rain showers, the furniture should be tilted slightly after the rain and
the moisture wiped off. When covering for a longer period of time, ensure
sufficient air circulation.
•
We recommend that you leave cushion covers on the cushion when cleaning
instead of removing them. Clean the outer cushion cover with clean water
and a soft brush. Remove stubborn dirt with a little soapy water and then
wipe with a clean cloth and clear water. Allow the cushions to air dry
completely after cleaning or before storage. Never put the fabrics in the
washing machine or dryer.
•
Avoid contact with sunscreen or tanning products.
•
The screws are made of stainless steel for greater durability. Do not
tighten the screws too much.
•
The frame is powder-coated. Use and transport can cause damage to the
paintwork. Touch the paintwork up in time with a dab of paint to prevent
rust.
•
Protect the sun lounger from excessive sunlight when not in use, otherwise
the colour may fade.
•
Store the sun lounger in a cool, dry and frost-free place in winter. The sun
lounger is not winterproof.
•
Please use individual parts only for sitting or lying down. They are not
suitable as a substitute for a ladder or as gymnastic equipment for
children.
•
The sun lounger and all associated parts are for private use only.
•
Assemble the individual parts on a carpet so that they are not damaged
during assembly.
•
Do not tighten the screws until all screws of the component are in the
correct position.
Note: To counteract premature fatigue of the material or contamination,
regular cleaning must be carried out. Damage or contamination caused by
insufficient care does not constitute grounds for complaint.