Adjustments; Adjustment Of The Opening Range - probst FTZ-MAXI-25 Instrucciones De Uso

Adjustments

5 Adjustments
5.1

Adjustment of the opening range

Before the product can be lifted and transported, the gripping range has to be adjusted to the dimensions
of the product.
Otherwise is not ensured that the clamping force for the secure gripping of the gripping good is adequate
and it could slide down!
•
The adjustment of the gripping range may never take place on both sides at the same time. Always
adjust the gripping range first to the one and then on the other side.
•
Lift the device approx. 0.5 m. Gripper arms must be locked and open (automatic release in position
"empty").
•
Release bolt with half ring (1), through pulling out of the safety clips (2).
•
Pull the bolt with half ring (1) out at the opening range adjustment.
Slide the rectangular tubes apart, until the opening range is about 5 cm greater than the product.
•
Insert the bolt with half ring (1) again and safe it with the safety clip (2).
The adjustment of the gripping range has to follow general symmetrical.
That means, it must be used in each case the same adjustable hole with both rectangular tubes.
Caution while adjustment work. There is danger of injuring the hands!
Use safety gloves! →
Defective safety elements (splints) must be replaced absolutely!
Gripping range adjustment
53100344
1
2
13 / 20
Gripping range adjustment
GB