universalblue UBH2304-21 Manual De Instrucciones página 43

WARNING: To avoid electric shock, ensure that
the device circuit is open before changing the lamp.
WARNING: Cut off all supply circuit connections
before accessing the terminals.
 Do not use cut or damaged cords or extension cords
other than the original cord.
 Make sure that there is no liquid or humidity in the outlet
where the product plug is installed.
 The rear surface of the oven also heats up when the
oven is operated. Electrical connections shall not touch
the rear surface, otherwise the connections may be
damaged.
 Do not tighten the connecting cables to the oven door
and do not run them over hot surfaces. If the cord melts,
this may cause the oven to short circuit and even a fire.
 Unplug the unit during installation, maintenance,
cleaning and repair.
 If the power supply cable is damaged, it must be
replaced by its manufacturer or authorized technical
service or any other personnel qualified at the same
level, in order to avoid any dangerous situation.
 Make sure the plug is inserted firmly into wall socket to
avoid sparks.
 Do not use steam cleaners for cleaning the appliance,
otherwise electric shock may occur.
 An omnipolar switch capable to disconnect power
supply is required for installation. Disconnection from
power supply shall be provided with a switch or an
43