Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
● OPERATING INSTRUCTIONS ●
S
ELECTING OPERATION MODES
1
Press
to start the operation.
2
Press
to select operation mode. Each press
changes mode in the following order:
<for MSZ-GS (Heat pump)>
(AUTO)
(COOL)
<for MSY-GS (Cooling only)>
(I FEEL)
(COOL)
3
Press
or
to set the temperature.
Each press raises or lowers the temperature by 1°F
(1°C).
Press
to stop the operation.
• The same setting is selected the next time by simply pressing
Note:
Operation indicator lamp
The operation indicator lamp shows the operation state of the unit.
Indication
Operation state
The unit is operating to
reach the set temperature
The room temperature
is approaching the set
temperature
Lit
Not lit
En-5
(DRY)
(HEAT)
(DRY)
(FAN)
.
Room temperature
About 4°F (2°C) or more
away from set temperature
About 2 to 4°F (1 to 2°C)
from set temperature
AUTO mode (Auto change over)
(MSZ-GS Heat pump)
The unit selects the operation mode according to the difference between the
room temperature and the set temperature. During AUTO mode, the unit
changes mode (COOL↔HEAT) when the room temperature is 4°F (2°C)
away from the set temperature for more than 15 minutes.
I FEEL mode (MSY-GS Cooling only)
The unit selects the operation mode according to the room temperature
when I FEEL is selected. When the room temperature is higher than 77°F
(25°C), COOL is selected (set temperature: 75°F [24°C]). When the room
temperature is lower than 77°F (25°C), DRY is selected. However, when
operation is stopped and then started within 2 hours, the mode which has
been selected previously is operated.
Note:
During COOL operation, the set temperature may not be changed when
the room temperature is more than 4°F (2°C) higher than the set tempera-
ture. In this case, please wait until the room temperature drops to within
4°F (2°C) of the set temperature.
COOL mode
Enjoy cool air at your desired temperature.
Note:
Do not operate COOL mode at very low outside temperatures.
(less than 14°F [-10°C])
Water condensed in the unit may drip and wet or damage furniture, etc.
DRY mode
Dehumidify your room. The room may be cooled slightly.
Temperature cannot be set during DRY mode.
HEAT mode (MSZ-GS Heat pump)
Enjoy warm air at your desired temperature.
FAN mode (MSY-GS Cooling only)
Circulate the air in your room.
Publicidad
Tabla de contenido
