Dunsch DU34040-55 Instrucciones Originales página 18

-
Switch on the motor carefully according to instructions and with feet well
away from the blade(s).
-
Do not tilt the machine when switching on the motor, except if the machine
has to be tilted for starting. In this case, do not tilt it more than absolutely
necessary and lift only the part, which is away from the operator.
-
Do not put hands or feet near or under rotating parts. Keep clear of the
discharge opening at all times.
-
Do not transport the machine while the power source is running.
-
When cutting, make sure do not touch objects such as wire fences or plants
frame-holder. Doing so can damage the blade beam.
-
Hold the electric hedge trimmer with both hands firmly, with one hand on
the rear and with the other hand on the front handle. Thumb and fingers
must firmly embraced.
-
Stop the machine, and remove the battery from the device. Make sure that all
moving parts have come to a complete stop：
• whenever you leave the machine,
• before clearing blockages or unclogging chute,
• before checking, cleaning or working on the machine,
• after striking a foreign object. Inspect the machine for damage and make
repairs before restarting and operating the machine; if the machine starts
to vibrate abnormally (check immediately),
• inspect for damage,
• replace or repair any damaged parts,
• check for and tighten any loose parts.
4) Maintenance and storage
-
Keep all nuts, bolts and screws tight to be sure the machine is in safe working
condition.
-
Be careful during adjustment of the machine to prevent entrapment of the
fingers between moving blades and fixed parts of the machine.
-
Always allow the machine to cool down before storing.
-
When servicing the blades be aware that, even though the power source is
switched off, the blades can still be moved.
-
Replace worn or damaged parts for safety. Use only genuine replacement
parts and accessories.
GB
16