Installation - Watts BB-M101 Guia Del Usuario

Installation

NOTICE
Installation diagrams for BB-S101 can be found on page 6 of
this manual. See document IOM-WQ-BB-S100 for BB-S100
system installation instructions using the instructions below for all
U-M101 monitor related retrofits.
Unpack the contents of the BB-M101 carton and confirm all
components are present in the kit. A complete kit includes
monitor, flow meter, meter cable, power transformer/cable and
monitor mounting hardware. If any components are missing,
please contact your Watts representative.
1. Install the 1" flow meter in the in the conditioned water outlet
line of the system it is monitoring. The arrow on the flow meter
must point in the direction of water flow. See Figure 1.
Use PTFE plumbing tape only on the meter threads.
2. Lift up on tab at bottom center of BB-M101 monitor
display screen and separate display screen from base. A small
amount of force will be required for separation due to the
internal interconnecting plug between the base and monitor.
See Figure 2 for display screen and base separation.
3. Mount the BB-M101 monitor base to the mounting surface.
Mounting hardware is provided for drywall mounting. Installer to
provide additional hardware for alternate mounting surface types.
See Figure 2 for mounting detail.
WARNING
!
Locate any hidden electrical wires or plumbing before drilling
into mounting surface to mount monitor. Select mounting
location to ensure monitor will not come into contact with
water of any kind.
Figure 1
4. Press monitor display fully into base to mount display screen
to base.
NOTICE
Meter and power cables are 59" long. Select monitor mounting
location to accommodate connection to meter and electrical outlet.
Monitor
Base
Monitor
No. 6
Screen
Screw Size
5. Connect monitor cable to meter cable.
6. Plug power supply transformer into GFCI electrical outlet and
follow the instructions beginning on page 7 of this for product
set up and operation.
5
Pre-Drill
Hole Size ⁄ "
3
32
*Mounting Surface
Anchor for No. 6
Screw Size
*Do Not Use If Wood Stud Is Located
Figure 2
Mounting
Surface