KRHÜNER 80755 Manual De Instrucciones página 14

serious personal injury.
ො Use personal protective equipment. Always wear eye protection. Protective equipment
such as dust mask, non-skid safety shoes, hard hat, or hearing protection used for ap-
propriate conditions will reduce personal injuries.
ො Prevent unintentional starting. Ensure the switch is in the off-position before connect-
ing to the power source and /or battery pack, picking up or carrying the tool. Carrying
power tools with your finger on the switch or energising power tools that have the
switch on invites to accidents.
ො Remove any adjusting key or wrench before turning the power tool on. A wrench or a
key left attached to a rotating part of the power tool may result in personal injury.
ො Do not overreach. Keep proper footing and balance at all times. This enables better
control of the power tool in unexpected situations.
ො Dress properly. Do not wear loose clothing or jewelry. Keep your hair, clothing and
gloves away from the moving parts. Loose clothes, jewelry or long hair can be caught
in the moving parts.
ො If your device is provided of a dust extractor, ensure it is connected and properly used.
It can reduce dust-related hazards.
ො Do not force the power tool. Use the correct power tool for your application. It will do
the job better and safer as it was designed for that kind of task.
ො Do not use the power tool if the switch does not work properly. Any power tool that
cannot be controlled with the switch is dangerous and must be repaired.
ො Disconnect the plug from the power source and/or the battery pack from the power
tool before making any adjustments, changing accessories, or storing .
ො Store out of the reach of children and do not allow persons unfamiliar with the power
tool or these instructions to operate the power tool. Power tools can be dangerous in
the hands of untrained users.
ො Maintain the power tool. Check for misalignment or binding of moving parts, breakage
of parts and any other condition that may affect the power tool's operation. If dam-
aged, have the power tool repaired before any use.
ො Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting
edges are less likely to bind and are easier to control.
ො Use the power tool, accessories, tool bits, etc. in accordance with these instructions,
taking into account the working conditions and the work to be performed. The use of
the power tool for operations different from those intended could result in a hazardous
situations.