Charging; Bluetooth Connection - Bigben PARTY PARTYBTHPXL Manual De Instrucciones

4. Down button. Press the < button to lower the volume and return to the previous track via
Bluetooth, SD and USB – Press briefly to reduce the volume.
5. Lighting button. Press briefly to scroll between the lighting modes.
• RGB colours with flame effect.
• The colours react in synchronisation with the music. The light effect starts at the bottom.
• The colours react in synchronisation with the music. The light effect starts from the bottom
and top.
• The colours react in synchronisation with the music. The light effect starts from the top.
6. Multiple volume control. Multiple volume selection. Press briefly to toggle between the
microphone input volume (H), echo amount (E), and output volume (V) levels indicated
from 0 to 30 on the front LED display. Turn the volume control knob to adjust each level.
7. Microphone priority button. When activated, if the user speaks into the microphone,
the music stops automatically.
8. Input mode button. Switches between all the input modes available. BT/USB/SD/AUX
modes available. The LED display indicates which mode has been selected.
9. Main volume control. Use the master volume control to increase and decrease the
volume of your speaker. Press the multi-volume button to toggle between the microphone
volume and the amount of echo and adjust these values to your preference.
10. Microphone inputs x 2
11. AUX-IN input 3.5 mm. Note: The reset button is also located in this cavity. If the system
locks up, simply use a thin object such as a needle or paper clip to press this button to
reset the product.
12. USB/SD card input
Note: Maximum supported capacity of 32 GB for USB/SD card reading. MP3 music encoding
only.
13. Plug adapter 9V 5A (please only use the adapter provided with the speaker)

Charging

Connect the USB cable to the charging port on top of the speaker. During charging, the LED
indicator turns red. The charging LED light switches off when charging is complete. A beep
will sound a few minutes before the battery is discharged. As soon as the first beep is heard,
remember to plug in your speaker to recharge it.
Note: If you experience any drop in volume during battery use, please put the speaker back
on mains power as this will be due to low battery.

Bluetooth connection

When the speaker is turned on, the speaker automatically switches to Bluetooth search mode.
Make sure the microphone is plugged in and turned on.
Search for "PARTYBTHPXL" on your mobile device and select it. Once found, a beep will
sound to indicate that the speaker is connected to the device.
During pairing, the LED indicator flashes. Once paired, it will turn solid blue.
All connections are located at the rear. The playback mode will automatically default to
the connected device. Disconnect the USB-SD card or the auxiliary cable to return to the
Bluetooth connection.
Make sure your storage media is in FAT 32 format.
- EN 13 -