SOLAC Elogio Instrucciones De Uso página 7

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1
SAFETY THERMAL PROTECTOR:
- The appliance has a safety device, which
protects the appliance from overheating.
- When the appliance switches itself on and
off repeatedly, for reasons other than the
thermostat control, check to ensure that there
are no obstacles that impede correct air entry
or expulsion.
- If the appliance turns itself off and does not
switch itself on again, disconnect it from the
mains supply, and wait for approximately
15 minutes before reconnecting. If the
machine does not start again seek authorised
technical assistance.
CLEANING
- Disconnect the appliance from the mains
and allow it to cool before undertaking any
cleaning task.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an
acid or base pH such as bleach, or abrasive
products, for cleaning the appliance.
- Do not let water or any other liquid get into
the air vents to avoid damage to the inner
parts of the appliance.
- Never submerge the appliance in water or
any other liquid or place it under running
water.
- If the appliance is not in good condition
of cleanliness, its surface may degrade
and inexorably affect the duration of the
appliance's useful life and could become
unsafe to use.
- Remark: When the appliance is used as a
heater after long periods in storage or after
having been used solely as a fan a small
amount of smoke may be produced. This is
not important and is due to the heater burning
dust deposits which have accumulated on
the heating element. This phenomenon may
be avoided by cleaning the inside of the
appliance beforehand through the grill with a
vacuum cleaner or pressurised air.
EN

Publicidad

Tabla de contenido
loading

Tabla de contenido