3
Pair a remote
Pair a remote control that is able to program blinds. See pages 6 and 7
for remote controls details. In this manual CM-12 is displayed.
Shortly press the program button on the
3.1
motor. The blind will start stepping, indicating
that program mode has been activated.
(The blind remains stepping until the program
mode is de-activated.)
Select a desired channel for the blind using the
3.2
channel selection button on the remote control.
Press the pair button on the back of the remote
3.3
control to pair the blind to the selected channel.
The blind will shortly stop stepping indicating
that the remote has been paired to the blind.
Repeat steps 3.1 - 3.3 to remove a blind from
a channel.
End limits must be programmed to use a blind properly and to prevent it from being damaged.
Proceed to step 9 if end limits are already set.
4
Check direction of rotation
WARNING:
risk of damage.
Stop the blind before reaching
the end positions.
MOTION CM-09/10 ELECTRONIC TUBULAR MOTOR
Up
Down
Channel
indicator
Channel
Selection
Shortly press the down button to check if the
4.1
blind unrolls the right way. If the blind moves
up the direction of rotation must be changed.
Simultaneously press the up and down button
4.2
to change the direction of rotation.
Pair
Button