Motion CM-09 Manual página 19

15 Reset the blind
It is possible to only delete end limits or to do a default factory reset.
A default factory reset will delete the end limits and remove the connection to any paired
remote.
Press the program button on the motor to activate program mode.
15.1
Delete end limits: To delete the end limits of the blind hold the program button
until the blind stops stepping for the first time, keep holding the button until the
blind stops stepping for the second time. (approximately 10 seconds)
Default factory reset: To reset the blind to the default factory setting hold the button for at least 20
seconds.The blind will stop stepping twice. After the second stop the blind will give one extra step to
confirm the default factory reset.
MOTION CM-09/10 ELECTRONIC TUBULAR MOTOR