Configuration; Linkup Configurator App; Sensor Configuration - Veratron LINK UP Serie Manual De Instrucciones

CONFIGURATION

LINKUP CONFIGURATOR APP

To configure the sensor, some parameters like sensor type, its calibration or warning threshold, must be
calibrated through the Link Up gateway.
This is possible through the "Link Up Configurator" smartphone App, which can be downloaded free of
charge from the stores of both Android and iOS devices.
A simple and detailed explanation of the configuration process is also available as in-app instructions.
Thanks to the passive embedded NFC receiver, the Link Up gateway can be configured, as described below,
without the need of a power supply.

SENSOR CONFIGURATION

LINK UP
CONFIGURATOR
1. Launch the "Link Up Configurator" App and read
the actual configuration of the Link Up device by
"tapping" the smartphone onto the Link Up
wireless area (indicated by the NFC symbol)
The readout is necessary before you can write
new configurations on the Link Up
NOTE: The antenna position on the smartphone
depends on the model.
Please refer to the smartphone manufacturer
manual.
CONFIGURATION
B000647