Operation; Start / Stop The Machine; Maintenance; Clean The Machine - Powerworks PAM301 Traducción De Las Instrucciones Originales

NOTE
Set the inflator to low pressure mode to deflate.
Figure 6.
3

OPERATION

WARNING
Always wear eye protection.
WARNING
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
3.1

START / STOP THE MACHINE

Figure 7.
WARNING
Always avoid over-inflation and never leave the inflator
unattended when in use.
1. Press the On/Off button.
2. Push the mode selection button to choose high pressure or
low pressure mode.
3. The digital pressure display will show the current
pressure (in 1 PSI increments) of the item you are
inflating on the upper section of the LCD Screen.
4. Press air pressure increase button to increase PSI, or press
air pressure reduction button to decrease PSI.
5. To start the inflator, push the start / break button.
6. To change the target PSI level, push the start / break
button again and the adjust level.
7. To stop the inflator before it reaches the target PSI level,
push the start / break button. To resume inflation, simply
press the button again. Press the On/Off button to turn the
inflator off. The power automatically cycles off after five
minutes of no activity.
• When you work under dim ambient, press the LED light
button to turn on the light.
• When the LCD readout screen is displaying the target
PSI, the LCD readout will flash 3 times at the desired
preset level.
• The pressure value of the low pressure mode is fixed
and cannot be adjusted.
• The inflator will shut off automatically at the desired
target PSI level that you have programmed into the
target PSI setting.
• The inflator has a tolerance of -5 PSI and will
automatically shut off accordingly.
• If the current pressure of the item you are inflating is
greater than the target PSI, the inflator will not turn on.
NOTE
English
4

MAINTENANCE

Remove the battery pack from the machine before
maintenance.
Do not use strong solvents or detergents on the plastic
housing or components.
4.1

CLEAN THE MACHINE

The machine must be dry. Humidity can cause risks of
electrical shocks.
• Clear the unwanted material out of the air vent with a
vacuum cleaner.
• Do not spray the air vent or put the air vent in solvents.
• Clean the housing and the plastic components with a
moist and soft cloth.
5

TECHNICAL DATA

Voltage
Working Pressure （max）
Weight Without Battery
Air Hose (high pressure)
Air Hose (low pressure)
Measured sound pressure
level
Measured sound power level L
Guaranteed sound power lev-
el
Battery Model
Charger Model
The recommended ambient temperature range:
Item
Machine storage temperature
range
Machine operation tempera-
ture range
Battery charging temperature
range
5
WARNING
WARNING
CAUTION
24 V
160 PSI
4.34 lbs. (1.97 kg)
80 cm
42 cm
L = 79.07 dB(A) , K = 3
PA
dB(A)
= 94 dB(A)
WA
L = 97 dB(A)
WA.d
P24B2/P2448B2 and other
BAM series
P2448C and other CAM ser-
ies
Temperature
32°F (0°C) - 113°F (45°C)
32°F (0°C) - 113°F (45°C)
39°F (4°C) - 104°F (40°C)
EN