TMEZON MZ-IP-V739B Manual Del Usuario página 7

Camera
32.1mm
48.14mm
View angle
Definition
LEDs for night
Day/Night
128.14mm
Power consumption
Power supplier
Operation temp.
Installation
Installation for outdoor doorbell
̊
115
You have two options to install outdoor doorbell: Angle mount and Surface mount
Angle mount
Hatch Hole
Waterproof cover
Angle bracket
Note on doorlock's connection
The electric locks are usually divided into NC lock and NO lock, their wiring is different,
the NC lock need to work with the additional power supply control.
Note:
1. The doorbell or the monitor will not provide the power to door lock.
2. The doorbell can support door locks within 30V.
3. Door lock's power supply depends on its door lock, if the door lock is 12V,
the corresponding power supply is 12V, etc.
4. Make sure the input voltage from the monitor to the outdoor doorbell must reach 11.7V when unlocking.
NO Lock: Always closed when power or power off, only open when press unlock.
NC Lock: Always open when power off. Closed when power and open after press unlock.
1/3 inch CMOS camera
o
115 (H.)
1080P(1920*1080)/720P(1280*720)/CVBS
o
IR LEDs(120 )
IR-CUT
300mA max.
Supplied from indoor monitor
o o
-20 C~+60 C
Surface mount/Angle mount
Surface mount
Hatch
Waterproof cover
GB-11
Method 1: NO Lock connection without power supply control (NO lock only)
Power(DC12V) 1
Audio 2
To indoor
GND 3
monitor 4
Video
5 6
b
Method 2: NO & NC Lock connection with power supply control
NO lock
Electronic lock
NC lock
Electric mortise lock
1 2 3
4 5 6
7 8 9
* 0 #
Magnetic lock
Access controller
Cathode lock
AC/DC power
supply for
unlocking
(not included)
Electronic lock
(not included)
Power supply control
Doorbell
DOOR
EXIT
Monitor
1
2
EXIT
4 pin cable
GB-12
Monitoring
Talk
Unlock
Hang up