Ryobi RY36BI1800A Manual De Instrucciones página 7

BATTERY PORT LED FUNCTIONS
LED indicator Battery pack
status
Power Without
battery pack
Testing Hot battery
pack
Cold battery
pack
Error Error
Deeply
discharged
■ Reinstall the battery pack. If the LED status repeats a second time, try charging a different
battery.
■ If a different battery charges normally, dispose of the defective pack (see the battery pack
manual for instructions).
■ If a different battery pack also indicates an error, replace the charger.
Charging Fast charging
Ready Battery full
TROUBLESHOOTING
Problem
The product does not turn
on.
The AC receptacle does
not work.
The product unexpectedly
turns off .
The charger does not work.
If the problem persists after trying the above solutions, contact your nearest authorised service centre for assistance.
Red Green
LED LED
Solid -
Flashing -
Flashing -
Flashing Flashing
Flashing -
- Flashing
- Solid
Possible cause
The battery pack is not charged.
The main power button was
released too quickly.
The AC output is not active or the
AC power button was released
too quickly.
The charger is connected.
The connected device is
defective.
The product is overloaded.
The battery pack temperature is
outside of the normal operating
range.
The battery pack has low or no
charge.
The battery packs are faulty.
The battery pack temperature
is outside of normal operating
range.
The connection between the
battery pack and inverter is not
good.
The charger's voltage is outside
the normal range.
The battery pack is defective.
Description
Ready to charge the battery pack
When the battery pack reaches cooled temperature, the
charger begins charge mode.
When the battery pack reaches warmed temperature, the
charger begins charge mode.
Battery pack or charger error
The charger conditions the battery pack until normal
voltage is reached, then begins charge mode.
The battery is charging.
Charging is complete.
Solution
Recharge the battery pack.
Press and hold the main power button for 2
seconds.
Press and hold the AC output button for 2 seconds.
There is no power output (AC and USB) while the
product is charging. Disconnect the charger after
the battery packs are fully charged.
Try a diff erent device.
Remove the loads and press the AC output button
to reset the power hub.
Make sure that the battery pack temperature is
between -20 °C and 49 °C.
Recharge the battery pack.
Have the product serviced by an authorised service
centre.
Make sure that the battery pack temperature is
between 0 °C and 45 °C.
Reinstall the battery pack. If problem persists, use
another battery pack.
Use another charger.
Use another battery pack.
7
Original Instructions
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
UK
TR