Di4 Acqua Rs3 Instrucciones Originales página 47

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1
Do not direct the jet at the machine, socket and wire-
connection.
Check the hose connection before operation, the leaky and
defective parts shall be repaired or replaced immediately.
To prevent the maximum operating pressure, the outlet
hose should be at least 3M long.
Do not use the pressure cleaner in inflammable
environment.
By operation keep the hand away from the water jet and
hose.
Sometimes the reflected water is also dangerous.
Do not direct the water to fire or hot equipment. Hot
particles and steam are dangerous.
Use only hand to squeeze the trigger, do not jam the
trigger in the ON position.
A fluctuating or high water pressure shows signal of
defect or accumulation of the calcium in the hose. In this
case turn off the machine immediately.
Do not run the cleaner without water. This will cause
damage to it.
Before starting the machine, fully open the water supply
tap. Be careful not to bend the hose.
When the machine hose or tube freeze in winter, do not
use it. Before storing the water must be drained from the
machine. Always store the pressure washer in a secure
dry and frost protected place
Do not use the machine in a dirty place.
47

Publicidad

Tabla de contenido
loading

Tabla de contenido