Maintenance Instructions; Structural Inspection - Gray TAJS-2000 Manual Del Propietário

All inspection and maintenance procedures must be performed after the jack has been removed from
service. Failure to heed this warning may result in personal and / or property damage.
The owner must inspect, or appoint a knowledgeable person to inspect, the jack. Visual inspection should be
made before each use of jack, checking for abnormal conditions. Regular inspections should be made weekly
for daily use and monthly for intermittent use. Each jack must be inspected immediately if subjected to an
abnormal load or shock. Any jack which appears to be damaged in any way, is found to be badly worn, or
operates abnormally shall be removed from service until necessary repairs are made.
1. All controls should operate freely. Wheels should rotate freely.
2. All warning and capacity labels should be readable and complete. Wash external surfaces of jack,
labels, and decals with a mild soap solution. Do not allow water to run down the ram or the post and
into the cylinder area. If this happens, tip the jack forward until it rests on the handle and allow the
water to drain from the cylinder.
3. Lubricate all rotating and sliding portions of the jack monthly.
The jack must be removed from service and inspected for damage immediately if the jack is subjected to
an abnormal shock or load. Failure to heed this warning may result in personal and / or property
damage.
NOTICE: The owner must inspect, or appoint a knowledgeable person to inspect the jack for signs of
corrosion and / or excessive wear. Visual inspection should be made before each use of jack, checking for
abnormal conditions. Regular inspections should be made weekly for daily use and monthly for intermittent
use. Each jack must be inspected immediately if subjected to an abnormal load or shock. Any jack which
appears to be damaged in any way, is found to be badly worn, or operates abnormally shall be removed from
service until necessary repairs are made.
1. Inspect ram, lift post, extension post regularly and replace if they are cracked, chipped or show signs of
excessive wear. Holes for the pins should not be elongated.
2. Inspect pins for deformities or excessive wear. Pins must be able to insert fully into the posts and ram in
all positions.
3. The ram should extend and retract smoothly through its full range.
4. Inspect airlines for leaks or kinks. Replace defective airlines.
If any irregularities or problems are detected during an inspection, the jack must be removed from service
immediately and repaired. Contact customer service at the address and numbers on the back cover of this
manual.

Maintenance Instructions

Structural Inspection

WARNING
WARNING
5