Warranty Conditions - Thulos KOOL BREEZE TH-KB13 Manual De Instrucciones

TROUBLESHOOTING
Do not repair or disassemble the unit by yourself, unauthorized repair attempts will
invalidate the warranty and may cause bodily harm.
Issue
No power
No dust elimination 1. The honeycomb filter is blocked.
Odour emission
from unit
ENVIRONMENT
This appliance should not be put into the domestic garbage at the end of its
durability, but must be offered at a central point for the recycling of electric and
electronic domestic appliances. This symbol on the appliance, instruction
manual and packaging puts your attention to this important issue.
The materials used in this appliance can be recycled.
By recycling of used domestic appliances, you contribute an important push to the protection
of our environment. Ask your local authorities for information regarding the point of
recollection.

WARRANTY CONDITIONS

- This device is covered against any failure caused by the system itself
manufacturer's electrical
- The warranty does not cover breakdowns due to misuse, knocks or cosmetic damage.
- The manufacturer reserves the total freedom to cancel the right to guarantee
in case of observing any negligence on the part of the user of the device.
- The person responsible for managing and processing the guarantee of the device in case of
breakdown it will be the store where the device was purchased along with your purchase
invoice.
Possible Reason
1. Power cord is not plugged in
2. No power from the socket.
3. Honeycomb filter support is not
installed correctly
4. The power button has not been
pressed.
2. The air inlet is blocked
1. New unit. When the unit is used
for the first time, the Honeycomb
cooling media will have an odour,
which will dissipate within a week of
use
2. Honeycomb filter may have
developed mould or bacterial growth
Solution
1. Connect the power cord
2. Check socket is switched
on – test with a different
appliance.
3. Install the honeycomb
filter correctly.
4. Press the power button
1. Remove the honeycomb
filter and clean it.
2. Remove the obstruction
1. No action required
2. Clean the filter pads with
mild antibacterial
solution. Dry before use.