Set-Up; Align The Blade Assembly; Operation; Sleep Mode - EASYHOME WK1083-B Manual Del Usuario

4. Disconnect the USB charging cable
the USB charging cable

Set-up

Place the product in the desired location. Place it on a flat, dry, firm and sufficiently
stable surface. Ensure that the product is securely held in place.

Align the blade assembly

The blade assembly
transverse axis so that you can direct the airflow as desired.
− Move the blade assembly

Operation

Use the FAN button
switch off the product. If the product is switched on, the LED will be blue (see Fig. A).
− Push the FAN button to turn the product on. The blade assembly will start to run
at the lowest speed setting.
− To switch to the medium speed level, push the FAN button lightly a second time.
− To switch to the highest speed level, push the FAN button lightly a third time.
− To turn off the product, push the FAN button lightly a fourth time.

Sleep mode

Press the Mode button
running at the lowest speed level and speeds up until it turns off at the highest
speed level. After a short pause, the product automatically turns on again and the
process repeats. The LED
− Press the Mode button

Wireless charging

You have the option to charge a compatible smartphone that supports wireless
charging using the wireless charging function. Note that you can only use this
function as long as the fan is connected to the mains (see chapter "Charging the
Rechargeable Batteries").
− For this purpose, place your suitable smartphone horizontally on the loading
area . Make sure that it is positioned correctly. The loading area is marked with
4
a symbol. The LED
− The charging current is max. 10 W.
from the product.
8
can be rotated around the longitudinal axis and the
2
to the desired position (see Fig. A).
2
to switch on the product, change the speeds successively and
6
and the product will start sleep mode. The rotor starts
5
flashes in blue.
9
again and the product will switch itself off.
5
lights up green during the charging process (see Fig. A).
9
from the power source and disconnect
8
Operation
11