Alessi Plisse MDL07 Manual De Instrucciones página 15

after use or while changing glass
lift the spout into the CLOSED
position. (fig. 6)
Do not use the appliance for more
than 10 minutes consecutively.
CLEANING
• REMOVE THE PLUG FROM
THE SOCKET.
Clean the appliance immediately
after use to keep any pulp residue
from drying, which would make it
harder to remove.
• Take hold of the container to
disassemble the removable
components and take them to the
sink.
• Disassemble the cone, sieve and
container. (fig. 2)
• Remove any pulp residue from the
sieve.
• Press the spout of the container
down into the CLEANING
position.
The spout can be positioned in three
ways:
OPEN: Press down on the spout to
open the container and allow the
juice to flow into the cup.
CLOSED: Lift the spout upwards to
close the container, so that the
juice doesn't trickle out.
CLEANING: Press the spout all the
way down in order to clean the
container. (fig. 7)
NOTE: Before the spout can be
lowered into the CLEANING
position the container must be
removed from the motor unit.
The spout cannot be detached from
the container.
• Wash the cone, sieve and container
with hot water and washing-up
liquid.
• Rinse them carefully and dry well.
MDL07 USA Plissé spremiagrumi.indd 15 MDL07 USA Plissé spremiagrumi.indd 15
NOTE: The cone, the sieve and
the container can be washed in the
dishwasher, but place them in the top
rack to avoid contact with the heating
elements.
Also be careful about which
detergents and additives are used
and what temperatures are reached
during the wash cycle
as these factors may damage the
surface finish of the product.
Clean the motor unit with a damp
cloth ONLY.
ATTENTION!
NEVER IMMERSE THE MOTOR
UNIT IN WATER AND NEVER
RINSE IT UNDER RUNNING
WATER (FIG. 3)
• Before storing the citrus juicer,
wind the cable around the cable
wrap and use the slot provided to
lock it in place. (fig. 4)
IN THE EVENT OF
MALFUNCTION
In the event of a malfunction or when
in doubt, do not use
the citrus juicer and contact your
trusted Alessi retailer.
Advice to help you address some
minor issues
caused by mild distraction is provided
below:
• If the motor does not start:
- Is the power cable plugged into the
mains?
- Does your household mains
voltage match the specifications
listed on the bottom of the motor
unit?
15
26/11/20 10:45 26/11/20 10:45