Infiniton SPLIT-2323MF Manual De Instrucciones página 17

Buttons descripti_
1 4 .Anti-F
* TheAnti-F functions when the unit is turned off with the remate
controller in COOL, DRY ar AUTO mode. lt will operate in HEAT
mode (FAN mode far cool only units), with the interna! fan
running with weak flow far
moisture within the evaporator so as to prevent it from giving
off bad smell from mold.
* This function is not set in the factory. You may set it ar cancel it
any time you want as follows: With both the unit and the remate
controller OFF, point the remate controller at the unit and press
"Anti-F" button once, the buzzer will sound 5 times after 5 times,
indicating this function is set. O nce set, this function will remain
valid except when the unit is power off ar until it is cancelad.
* To cancel Anti-F:
1 . Power off the unit.
2. With both the unit and the remate controller OFF, point the
remate controller at the unit and press this button once, the
buzzer will sound 3 times after 5 times, indicating this function
is cancelad.
Note:
* With Anti-F activated, it is advised not to turn ON the unit
again before it is fully OFF.
* Anti-F function will be invalid when OFF timer is set.
�
1 5. � This button has two functions.
a. ELE.H
* lf this button is pressed in HEAT mode, the electric heating
will be turned on/off.
b. ECO
* lf this button is pressed in COOL mode, the unit will enter the
ECO mode which has the lowest electricity consumption, and
exit it automatically 8 hours after.
* C hanging modes ar turning off the remate controller will
automatically cancel the ECO function.
* Press ECO button in ECO mode to exit this mode.
Note: The ECO mode only works for inverter units.
www.infiniton.es
©@
o n _
__
3 minutes befare stop, to remove the