Factory settings
– Detection zone:
– Automatic fl ushing:
– Run-on time:
– Cleaning mode:
– Continuous water fl ow
(thermal disinfection):
– Water stop:
*= Value can only be adjusted using the KEUCO
Bluetooth app with the optional Bluetooth® adapter
(article No.: 59911 000000).
Mounting dimensions, refer to page 2
Installation, see from picture 1 on page 30
Flush potable water pipes thoroughly before and
after installation (observe EN 806 and 1717, as
well as DIN 1988).
Test connections for leaks with water pressure.
Use only neutrally netting silicone.
Operating, see from picture 21 on page 34
When the sensor washbasin mixer is ready for use:
- Hold hand in front of sensor window
- Water comes out at the preset temperature
Temperature setting, refer to fi gure 22 on page 35
- Change temperature by rotary button
Important information, please make sure to read!
~12 cm (factory setting)
deactivated
(factory setting)
1 s
180 s*
2 min*
20 s*
Servicing
Replacing the solenoid valve, refer to fi gure 23 on
page 35
Assemble in reverse order.
Replacing the mixing cartridge, refer to fi gure 24 on
page 35
Assemble in reverse order.
– Cartridge nut torque:
Cleaning aerator, replacing if necessary, refer to fi gure
25 on page 35
Assemble in reverse order.
For spare parts with order numbers, refer to page 43
For information about warranty and maintenance,
see the enclosed Care Instructions and Warran-
ty Card.
Disposal information! Equipment with this
labelling must not be disposed of in household
refuse, but must be disposed of at a collection
centre intended for this purpose.
Dispose of batteries according to laws and
regulations that are applicable locally.
EN
12-13 Nm
7