Compliance Information; Technical Specifications - Bellman & Symfon BE1433 Manual De Instrucciones

Regulatory symbols
This symbol confirms that the product meets the
Medical Device Regulation EU 2017/745.
This symbol indicates the manufacturer's serial number
so that a specific medical device can be identified. It's
available on the product and gift box.
This symbol indicates the manufacturer's catalogue
number so that the medical device can be identified.
It's available on the product and gift box.
This symbol indicates the medical device manufacturer,
as defined in EU Directives 90/385/EEC, 93/42/EEC and
98/79/EC.
This symbol indicates that the user should consult the
instructions for use.
This symbol indicates that it is important for the user
to pay attention to the relevant warning notices in the
instructions for use.
This symbol indicates important information for
handling and product safety.
Temperature during transport and storage:
–10° to 50° C, 14° to 122° F
Temperature during operation: 0° to 35° C, 32° to 95° F
Humidity during transportation and storage: <90%,
non-condensing. Humidity during operation: 15% to
90%, non-condensing.
Atmospheric pressure during operation, transportation
and storage: 700hpa to 1060hpa.
This device is designed such that it functions without
Operating
conditions
problems or restrictions if used as intended, unless
otherwise noted in the instructions for use.
With this CE symbol, Bellman & Symfon confirms that
the product meets EU standards for health, safety,
and environmental protection as well as the Radio
Equipment Directive 2014/53/EU.
This symbol indicates that the product shall not be
treated as household waste. Please hand over your old or
unused product to the applicable collection point for the
recycling of electrical and electronic equipment.
43

Compliance information

Hereby Bellman & Symfon declares that, in Europe, this
product is in compliance with the essential requirements of
the Medical Device Regulation EU 2017/745 as well as the
directives and regulations listed below. The full text of the
declaration of conformity can be obtained from Bellman &
Symfon or your local Bellman & Symfon representative.
bellman.com
Visit for contact information.
Radio Equipment Directive (RED)

Medical Device Regulation (MDR)

Waste Electrical & Electronic Equipment (WEEE)

RoHS Directive

REACH Regulation

EC Battery Directive


Technical specifications

Dimensions 100  65  27 mm, 4.0  2.6  1.1"
Weight
198 g, 6.98 oz. including batteries,
telephone cable and power cable
Mains power
5 V DC / 1000 mA
Backup batteries 2  1.5 V AA Alkaline
Connectivity RJ11 input to analogue telephone
network, 3.5 mm ext. trig input, Power
supply jack, Bluetooth Low Energy, BLE
Frequency ISM frequency: 868.30 MHz
Transmission power: 4mw (max.)
Bluetooth freq: 2400 – 2483.5 MHz
Transmission power: 4mw (max.)
Coverage ISM: Up to 250 m, depending on
the characteristics of the building.
Bluetooth: Up to 200 m
Compatibility iOS11 and later / Android 6 and later
iPhone 6S and later / Modern Android
devices
In the box BE1433 Mobile phone transceiver

(including batteries)
Screw and plug

Power adapter and power cable

Telephone splitter

 Telephone cord
EN
44