CORBERO CCHM300X Manual De Instrucciones página 9

Installation Important Instructions
Content that means [mandatory]
1. The safe operation of this appliance can only be guaranteed if it has been installed
to a professional standard in accordance with these installation instructions. The
installer shall be liable for any damage resulting from incorrect installation.
2. The entire installation process requires two professional installers. Wear dry
protective gloves during installation to avoid scratch or electric shock.
3. Fitted units must be heat-resistant up to 90°C, and adjacent unit fronts up to 70 °C.
4. Please use a 16A socket.
Content that means [prohibit ]
1. Do not install the appliance behind a decorative door or the door of a kitchen unit,
as this may cause the appliance to overheat.
2. Check the appliance for damage after unpacking it. Do not connect the appliance
if it has been damaged in transit.
3. Do not block the vent of the appliance and the gap between the cabinet and the
appliance.
4. Use extreme caution when moving or installing the appliance. It is very heavy, do
not lift the appliance by the door handle.
5. If the power cord or power plug is damaged, stop using the appliance
immediately, to avoid fire, electric shock or other injuries.
Content that means [note]
1. Be very careful when moving or installing the appliance to avoid damage to the
appliance or damage to the cabinets.
2. Before starting up the appliance, remove all packaging materials and accessories
from the cavity.
3. The power socket shall be accessible to users (such as next to the cabinet) for
easy power-o .
4. After installation is complete, make sure that the power plug is firmly inserted into
the socket.
5. Please refer to the "Cabinet Diagram" for the requirements of net depth of the
cabinet. The clearance between the cabinet bottom board and the rear board (or
wall) shall not be less than 50 mm.
EN-6