Specification; Intent Of Use; Tool Specification; Tool Dimensions - Stanley 71504 Manual De Instrucciones Y Servicio

E N G L I S H
2. SPE CIFICATION

2.1 INTENT OF USE

The 71504 Module is principally a piston and cylinder assembly. When coupled hydraulically to a compatible hydraulic
power source and the relevant nose assembly is attached, it is then used to install blind rivets up to 6.4mm (1/4") in
diameter, in Industrial Environments.
The placing module may only be used in accordance with the operating instructions for placing Stanley Engineered
Fastening structural rivets.
DO NOT use under wet conditions or in the presence of fl ammable liquids or gases.
The safety instructions must be followed at all times.

2.2 TOOL SPECIFICATION

Force:
Pressure:
Stroke:
Piston Bore Diameter:
Weight:

2.3 TOOL DIMENSIONS

All dimensions are shown in millimetres.
6

SPECIFICATION

Pull at stated pull pressure
Maximum
Piston Stroke
Minimum
Without nose equipment
O R I G I N A L I N S T R U C T I O N
METRIC IMPERIAL
22.7 kN 5103 lbf
400 bar 5800 PSI
26.0 mm 1.125 in
6.4 mm 0.25 in
1.98 kg 4.36 lbs