Using Broadcast; Changing The Radio Key - Bellman & Symfon BE1284 Manual De Instrucciones

Using broadcast

If you want the smoke alarm radio signal to be transmitted to all Visit receivers within
range, you can activate broadcast mode. This will override the radio key settings.
To activate broadcast, remove the smoke alarm from the bracket

and move the radio switches on the back of the alarm to the
110010 position, see the image to the right.

Changing the radio key

If your Visit system is activated for no reason, there is probably a nearby system that
triggers yours. In order to avoid radio interference, you need to change the radio key
on all units. The radio key switches are located on the back of the smoke alarm, under
the mounting bracket, see the image to the right.
Here is how you change the radio key:
1 Remove the smoke alarm from the bracket and move any
of the radio key switches 1 – 6 to the up = on position to
change the radio key.
2 Press and hold the test/function button on the receiver until the green and yellow
Visit LEDs blink alternately. Release the button.
3 Press the smoke alarm test/silence button until it sounds to sends the new radio key.
4 All Visit LEDs on the receiver blink 5 times to show that the radio key has been
changed. It then returns to normal mode.
Note: All Visit units must be set to the same radio key in order to operate as a group.
If broadcast mode is activated, all Visit receivers will respond regardless of the radio
key settings.
9
1
3
x5 x5
x5
2
EN
4
10