First Use Of The Machine; Electrical Connection; Use; Keep Warm - Wilfa FORMAT WSDK-2000X Manual De Instrucciones

FIRST USE OF THE MACHINE

EN
Please read these instructions carefully and keep them in a safe place. Boil fresh
water in the kettle at least twice before it is used for the first time. Use only plain
water with no additives or ingredients.

ELECTRICAL CONNECTION

Check the voltage where you use the device is the same as specified on the
appliance. For details on the label on the base plate.

USE

• Press the opening button to open the lid. Then fill the kettle with cold water
and close the lid by pressing down the cover until it locks.
• Important note: On the kettle body there is a water level gauge. Please
make sure not to fill in more than the maximum level as marked on the
gauge. If the kettle is overfilled, boiling water can be spilled out. Put the
kettle on the base. On the base station there is the " " button for selecting
different water temperatures.
• Note: flashing light indicates current water temperature in kettle, steady light
means the target temperature.
• Press the " " button which corresponds to your desired temperature. Press
the "wilfa" button to light up and the boiling process begins. As soon as
the water reaches the target temperature, the boiling stops and the "wilfa"
button light off. The heating element switches off automatically and the
process has been completed. Now the unit can be lifted up and the water
can be used.

KEEP WARM

• The "KEEP WARM" function allows you to maintain a specific temperature.
Press " " and select a temperature between 40/70/80/90/100°C. Once you
have selected your desired temperature, press the "wilfa" button. Then the
kettle heats up to the previously set value and holds it for 25 minutes.
INSTRUCTION MANUAL · WILFA FORMAT
8