1 - Open the box and remove all the packing material, the protective cover and all the parts.
Do not throw away the packaging until you have made sure the device works properly.
2 - Decide where to put the device. This device can only be used indoors. The device should
be installed close to a power outlet and at a height greater than 1.8 to 2 m from the floor.
NOTE:
Its design attracts bugs at 360º, so the device should be installed on the ceiling,
far from walls or barriers that might block the ultraviolet light.
3 - Use a drill to make 2 holes in the ceiling where you're going to install the electric insect killer
and insert a wall plug into each hole. You should use Ø 6mm wall plugs for safety.
4 - Screw a ceiling support into each wall plug so the chains supplied with the electric insect killer
can be attached.
1.- The power supplied to this unit must comply with electrical requirements on it's label.
Damage or fire may result if the incorrect power is used.
2.- Unplug the unit should an emergency situation occur.
3.- Of this device or in the case of a unit being used which has been abused; damaged either
accidentally or intentionally, modified, improperly installed or used in any manner contrary to
those included in the product instructions, guantee will automatically be canceled.
4.- The machine can not be washed or placed into water as it is not a waterproof device.
Putting the unit into water may result in electric shock and will damage the mechanical and
electrical components.
5.- Turn off and unplug the unit when performing maintenance or cleaning the unit.
6.- Turn the machine off if it appears to be operating in an unusual manner.
7.- Please contact the seller if you lose the operations manual for a replacement.
Please contact the seller if you find other problems not covered in the operation manual.
32
INSTALLATION
NOTICE