Power Setting - Domo DO7349H Manual De Instrucciones

POWER SETTING

You can choose from two power settings.
· Low: this is the default setting
· High
To use this, press the power setting button.
TEMPERATURE
You can set the temperature between 15°C and 35°C. First press the temperature button to activate this
mode. You can now use the decrease
temperature will flash on the display. If you do not press the button again for 5 seconds, the setting is
saved and you can read off the set temperature.
When the set temperature has been reached, the heater will switch off and the unit goes into standby
mode. If the ambient temperature falls to 2°C below the set temperature, the unit will switch on again.
TIMER
Automatic switch-off
When the unit is switched on, you can set a timer so that it goes into standby mode after a certain amount
of time.
1. Press the button to set the timer. The
2. You can set the timer between 1 and 24 hours by using the decrease
You can also keep this button pressed until you reach the desired setting. If you do not press
the button again for 5 seconds, the setting is saved and you can read off the timer and the set
temperature alternately on the display.
3. When the time has elapsed, the unit will switch off.
If you set the timer to 0 h, the mode will be cancelled.
Automatic switch-on
When the unit is in standby mode, you can set a timer so that the unit will automatically turn itself on
after a period of time.
1. Press the button to set the timer. The
2. You can set the timer between 1 and 24 hours by using the decrease
You can also keep this button pressed until you reach the desired setting. If you do not press the
button again for 5 seconds, the setting is saved. The time will flash on the display.
3. When the time has elapsed, the unit will switch on.
If you set the timer to 0 h, the mode will be cancelled.
OSCILLATION
Press the oscillation button to allow the heater to oscillate the air from left to right and vice versa. The
oscillation icon will appear on the display. Press this button again to stop this. If you switch the device off
with the on/off button, this function stops even if you have not pressed the oscillation button.
38
DO7349H
and increase buttons to set the desired temperature. The
symbol will appear on the display and '0' will flash.
symbol will appear on the display and '0' will flash.
and increase buttons.
and increase buttons.