Operation - Getting the most out of Your Mag Charger
Section 5
Switch Operation
Your Flashlight's Function Sets and the Functions
Within Each Set
The Mag Charger® LED flashlight includes powerful new electronics,
providing five different functions to choose from. Because not all
functions are equally important to all users, the Mag Charger® LED
offers an array of USER-CONFIGUR BLE FUNCTION SETS that LET YOU
PERSON LIZE the settings for QUICKEST CCESS to the FUNCTIONS
YOU USE MOST. The four available Function Sets are shown in the
below Function Sets Chart.
1
GENERAL
2
(Default)
Full Power
Low Power
Eco
10
Function Sets Chart
3
LAW
OUTDOOR
4
TACTICAL
ENFORCEMENT
Full Power
Momentary
Momentary
Low Power
Full Power
Full Power
Strobe
Eco
Strobe
®
LED Rechargeable Flashlight System
The five different functions are: – Full Power, Low Power, Strobe (flashes 12
times per second), Eco and Momentary On/Off (stays on only while the switch
button is held down). Not all of these functions are equally important to every
user. That is why these functions are organized into four different function sets
– so that you can personalize your flashlight to suit your needs, configuring it
for quickest access to the functions that best match your preference.
How To Choose A Function Within a Set - "Quick Click"
The available function sets, and the functions within each one, are shown in
the Function Sets Chart.
As it comes out of the package, your Mag Charger® LED flashlight is set to the
"Standard" function set (Function Set #1 in the chart). If you require only those
three functions (Full Power, Low Power and Eco), then you never have to
change it. You can select a function within that set by the "Quick Click"
method: Turn the flashlight on with one Quick Click and it is on at Full Power.
Turn it off, then turn it on with two Quick Clicks (about as fast as you would say
"Click Click") and it turns on at – the Low Power function. Turn it off, then turn
it on with three Quick Clicks (about as fast as you would say "Click Click Click")
and you have the Eco function.
Selecting a function within any of the other function sets works the same way
– starting with the flashlight off, invoke the desired function by applying 1, 2 or
3 "Quick Clicks", as the chart shows. For example, if you are in Function Set #2
and you want to select the Strobe function, begin with the flashlight off, apply
three Quick Clicks, and your flashlight will strobe.