Cleanfix S170 Navi Instrucciones De Uso página 24

Dust collector
The dust collector indicates its current status via the status-LED's on top of the lid:
Indicator light Common error
Fan error / overheating / the
dust collector's lid is not closed
Flashing red
The dust bag is not installed / not
Flashing red
flash Failed to pair / Not paired yet
simutane-
ously
1. Frequent suction can cause the overheating protection of the dust collector to
be triggered. Allow the suction motor to cool down and try again after approx.
30 minutes.
properly 2. Make sure the cover of the suction station is completely closed and seals well.
Also make sure that the robot vacuum cleaner is placed at the dust collector for
charging and that the charging contacts are in contact.
1. Check whether a dust bag is installed. If not, insert a new dust bag.
correctly in place 2. Check that the dust bag is installed correctly and that the sensors of the dust
bag holder detect the bag.
1. Press and hold the both buttons
for 5 seconds: The dust collector enters into pairing mode, the three indicators
on the dust collector flash green.
2. Press and hold the button
pairing mode, the indicators of the robot flash green.
3. Place the robot at the dust collector to charge, and wait till the voice prompt
indicates that the pairing is successful.
Solution
20
and on the dust collector simultaneously
for 5 seconds on the robot: The robot enters