Warranty Conditions - Toparc KOOLWELD 1 Manual Del Usuario

Operating manual
HOW TO USE
NEVER USE the cooling unit WITHOUT COOLANT when the pump is running.
1.)
Respect the minimum coolant level. Failure to do so may result in permanent damage to the cooling system's pump.
Ensure that the cooling unit is switched off before disconnecting the liquid-cooled torch's inlet and/or outlet pipes. Coolant is hazardous and
2.)
irritates eyes, mucous membranes and skin. The hot liquid can cause burns.
3.) Hot liquid burn hazard. Never drain the cooling unit after use. The liquid inside will be boiling, wait for it to cool down before draining.
TITANIUM: In «AUTO» mode, the cooling unit's pump will start running when the welding process is started. When the welding has
4.) stopped, the pump will continue to operate for 10 minutes. During this time, the liquid will cool the welding torch and brings it back to room
temperature. Leave the power source connected for a few minutes after welding to allow it to cool down.
The cooling unit must be switched off (OFF) to use an air-cooled TIG torch. For further instructions on how to do this, please refer to the power source's
HMI user manual.
OPTIONAL QUICK-RELEASE COUPLING
MESSAGES AND ERROR CODES
This equipment features a fault-monitoring system which is communicated directly to the appliance.
Please refer to the corresponding welding machine or HMI user manual.

WARRANTY CONDITIONS

The warranty covers any defects or manufacturing faults for two years from the date of purchase (parts and labour).
The warranty does not cover:
• Any other damage caused by transport
• The parts' normal wear and tear (e.g . cables, clamps, etc.)
• Misuse-related incidents (misfeeding, dropping or disassembling the device)
• Environmental failures (pollution, rust and dust, etc.)
Should the appliance malfunction, return it to your distributor together with:
- dated proof of purchase (receipt or invoice, etc.)
- a note explaining the breakdown
Translation of the original
instructions
This equipment can be fitted with a quick assembly kit (P.N. 076006) in order to very quickly
connect and disconnect a power source fitted to the cooling unit. Pleaser refer to the kit's user
manual (076006) to confirm that it is compatible.
KOOLWELD 1
11