Troubleshooting Guide - Kenwood JMP85 Instrucciones

Troubleshooting guide

Problem
The juicer will not start/
does not operate.
The juicer has stopped
during normal operation.
Juice is leaking from
underneath the bowl.
Juice does not exit juicing
outlet.
Too much pulp coming
out in juice.
Staining on juicing parts.
There is a squeaking noise
when juicing.
Cause
• No power.
• Juicing bowl not properly
aligned on power unit or lid
not locked correctly.
• Food clogging in feed tube
or at top of scroll.
• Clogging in filter and scroll.
• Food not cut into small
enough pieces.
• Juicer overloaded or
overheated due to heavy
load.
• Pulp stopper not fitted
or has come loose during
operation.
• Anti-drip stopper closed.
• Filter or scroll clogging.
• Very fibrous fruit/vegetable
being processed.
• Natural colouring from food.
• Friction between
ingredients and bowl.
6
Solution
• Make sure the appliance is
plugged in.
• Check that all parts are
fitted correctly.
• Press the reverse button
for 3-5 seconds. Repeat
the process 2-3 times until
blockage cleared.
• Do not attempt to open the
lid by force.
• Switch off, unplug and
remove the lid. Check if
any clogging. Remove food
if necessary and continue
juicing.
• Switch off, unplug and take
the juicer apart. Clear and
reassemble the juicer.
• Plug in and press the
"Reset" button and hold
for 1-2 seconds and start
operation as normal.
• Check that the pulp outlet
stopper is fitted correctly.
• Remove stopper and allow
juice to flow into juice
container.
• Cut food, especially fibrous
foods, into smaller pieces to
avoid the fibres wrapping
around the scroll.
• Rubbing with a cloth dipped
in vegetable oil will help to
remove discolouring.
• Normal operation.