Aux Connection - auna Dark Star 2000 Manual De Instrucciones

CONNECTION OF THE REMOTE POWER-ON
CABLE AND REMOTE POWER-OFF CABLE
• Connect the orange cable to a switched power cable of the car radio.
This controls the switching on and off of the amplifier.
• The switched power cable can act as the antenna of the radio.
AMPLIFIER INPUT CONNECTION
• This unit can be used with all car radios that have high power outputs.
• Separate basic car radio connection: Connect the car radio speaker
output cables to the high-power inputs +/- right and left.
• General-ground car radio connection: Connect the negative car radio
speaker output wire with the two remaining wires +/- right and left.

AUX CONNECTION

• Connect the AUX input cable to the RCA connector as described:
• "White" to the left preamp output of the car radio. "Red" to the right
preamp output of the car radio.
• Before connecting the preamplifier output of the car radio or other
equipment, make sure that the impedance and sensitivity match this
AUX connection.
INPUT SENSITIVITY CONTROL
• Control the input sensitivity to the car radio.
EN
17