Aukey SK-A6 Manual Del Usuario página 6

Notes
● The speaker will automatically enter standby mode after 10 minutes in pairing mode if no
devices are paired
● The speaker will automatically turn off after 10 minutes in standby mode
● If your paired device is switched off or manually disconnected, the speaker will enter pairing
mode and automatically enter standby mode after 10 minutes
● If the speaker or connected device exceeds the operating range (10m), the speaker will
disconnect. The connection to the last successfully connected device will be re-established
once you re-enter wireless range within 10 minutes. To connect to other devices, repeat the
previous"BT Pairing" steps
Playing Audio via Audio Cable
Connect the SK-A6 to your PC, laptop, or other device with audio output using the included
3.5mm audio cable. Press and hold the power button for 2 seconds to turn on and the triangle
indicator will light up solid white.
Notes
● The speaker will disconnect from your phone or other paired devices when an audio cable is
plugged into the audio input jack. Short-press the mode button or unplug the audio cable to
switch back to BT mode
● When playing audio using the audio input jack, short press the volume + / - to adjust the
volume. Play/pause on the speaker is disabled in audio input mode
● For some computers, you may need to access the audio control panel to manually set the
speaker as the default audio device
Connecting Multiple Speakers
1. Turn on the SK-A6 speaker you want to be the main speaker and connect it with an audio
output device (such as a phone) via BT or audio cable
2. Turn on all other SK-A6 speakers that you want to sync with the main speaker. Then press and
hold the play/pause button for 5 seconds until the triangle indicator turns solid green
3. Press and hold the play/pause button on the main speaker for 3 seconds with the circle indicator
rotating blue to enter speaker sync mode
- 04 -