Features; Assembly - Power Stroke PSL18CS Manual Del Operador

PRODUCT SPECIFICATIONS
Motor ..................................................................18 Volt DC
Blade Diameter ...................................................... 5-1/2 in.
Blade Arbor ..............................................................10 mm
KNOW YOUR CIRCULAR SAW
Before use of this product, familiarize yourself with all
operating features and safety rules.
SWITCH TRIGGER
The saw has a conveniently located switch trigger on the
underside of the handle.
SPINDLE LOCK
The spindle lock allows you to secure the blade when turning
the blade screw.
BLADE WRENCH STORAGE
Convenient wrench storage for quick blade changes.
UNPACKING
This product requires assembly.
 Carefully remove the tool and any accessories from
the box. All items listed in the Includes section must be
included at the time of purchase.
WARNING:
Items in this Assembly section are not assembled to
the product by the manufacturer and require customer
installation. Use of a product that may have been
improperly assembled could result in serious personal
injury.
 If any parts are damaged or missing, please call
1-877-617-3501 for assistance.
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.

FEATURES

Cutting Depth at 0° .............................................. 1-9/16 in.
Cutting Depth at 45° .............................................. 1-1/8 in.
No Load Speed .....................................4,400 r/min. (RPM)
LOCK-OFF BUTTON
The lock-off button reduces the possibility of accidental
starting.
BEVEL LOCK KNOB
The bevel adjustment feature allows you to make bevel cuts
up to 50º.
WIDTH OF CUT SCALE
When making straight cross cuts or rip cuts, the scale can
be used to measure up to four inches to the right side of
the blade. It can be used to measure up to one inch to the
left side of the blade.

ASSEMBLY

WARNING:
Do not attempt to modify this product or create
accessories or attachments not recommended for use
with this product. Any such alteration or modification is
misuse and could result in a hazardous condition leading
to possible serious personal injury.
ATTACHING THE BLADE
See Figure 1, page 12.
WARNING:
A 5-1/2 in. blade is the maximum blade capacity of the
saw. Never use a blade that is too thick to allow outer
blade washer to engage with the flats on the spindle.
Larger blades will come in contact with the blade guard,
while thicker blades will prevent blade screw from
securing blade on spindle. Either of these situations could
result in a serious accident.
 Remove the battery pack from the saw.
 Remove the blade wrench (5 mm hex key) from the
storage area.
 Depress the spindle lock and remove the blade screw
and outer blade washer.
NOTE: Turn the blade screw clockwise to remove.
Page 6 — English