Ducatillon Breedsafe V2 Manual De Instrucciones página 38

STARTING THE DOORMAN (Quick Setup)
A- Press MENU to turn the device on or out of sleep.
B- Press MENU again. The Quick Setup submenu appears.
C- Press MENU to validate and enter the submenu.
Setting the time
A- Using the arrows, access the time setting and then validate by pressing the MENU key. Press
the up arrow (24h mode) or down arrow (12h mode).
B- With the arrows, set the time and then press MENU to validate the time and access the
minutes. Adjust the minutes with the arrows and then validate thanks to the MENU button.
C- The device then offers you to continue (YES) or abandon the configuration (NO)
Press the corresponding arrow to validate the choice.
Stalling the door
Make sure the rope is securely attached to the door of your chicken coop. The rope should be in the
axis of the door, NEVER PUT IT IN A BIAS.
The batteries must be at maximum capacity before calibrating the door. The maximum permissible
load is 1kg. You can cut the excess wire once you have adjusted the length of the wire to the door in
the closed position.
Make sure the wire is tightly stretched when the door is closed before calibration.
A. Press the UP button and hold it to adjust the high (open) position of your
door then release the button and press MENU to validate. You can adjust the
high and low values during calibration.
B. Press the DOWN arrow and hold it to adjust the low (closed) position of your door,
then release the button and press MENU to validate.
C. The door will automatically return to the open position at the end of the calibration process.
D. The device then offers you to continue (YES) or abandon the configuration
(NO). Press the corresponding arrow to validate your choice.
ND: If the message "Door Error, recalibrate door" appears, be sure to recalibrate the door.