Ducatillon Breedsafe V2 Manual De Instrucciones página 39

Adjusting the opening and closing of the door
Opening and closing Simple
A- The configuration ends with the opening and closing mode. Select Simple
by pressing MENU and then validate by pressing the MENU key. 3 choices are then presented
: Manual, clock, and brightness probe. Choose with the arrows and validate with the MENU
button.
B- The clock or probe or manual mode selected for opening will determine the mode imposed
on closing. Please always set the opening first. If you choose a closing mode first and then
another opening mode, the closing mode will change automatically because it is modeled
on the mode selected by the opening.
MANUAL: If you choose this mode of opening/closing the door, you will only need to press the UP or
DOWN arrow to activate the opening or closing of the door.
CLOCK: If you choose this mode, the door will automatically open/close every day at a time you
choose.
LUMINOSITY PROBE: This mode allows you to open and close the door according to the outside light
thanks to the brightness sensor. You can shift the action up to 60 minutes when the
probe detects a sudden change in luminose (in 5-minute increments)
C- Adjust the time by pressing the arrows then validate using the
MENU button and repeat the same operation to adjust the minutes.
By choosing the manual mode, no settings are necessary. By choosing probe mode,
you can change the default lux values by going to the Regl.Lux Levels submenu (see advanced
settings).
Note: You cannot use multiple modes simultaneously. Example: if you open the door with clock
mode, you will not be able to close it with the probe. Only the clock mode will then be accessible.
Whichever mode you choose, you can always open and close the door manually
by tapping the UP or DOWN button. Be sure to reposition the door in its initial state (closed or
open). Opening and closing Multiple
Note: only the clock mode is accessible with the multi open/close function