Power Boost - Premier ED-4383 Manual De Instrucciones

OPTIONAL FEATURES (AVAILABLE ON SELECTED MODELS)
Mixing Shield
1.To attach:Place small tabs on the mixing shieldside of mixer.Push theshield backThe mixinginto place
inthegroove around the mixer.
2.Now insert the beaters or other attachments and use the mixer as you normally would.
3.To remove: Turn mixer off and,unplug. Eject beaters or other attachments.
4.Grasp mixing shield in one hand,while holding hand. Pull out, then up, to remove.
5.Wash mixing shield in hot, soapy water. Rinse and dry.
Mixer Lockdown Button
Use this feature to lock the mixer in the "down" position when using on the stand.

POWER BOOST

Press and hold down the button for additional power at any speed.
NOTE:
Never use Power Burst for more than two minutes at a time or motor may overheat.Bowl Rest™
This feature can be used on most large mixing bowls.Use the Bowl Rest while adding
ingredients or checking a recipe. To use,TURNMIXER OFF, then set the mixer on the
edge of the bowl.
CAUTION:
• Never use Bowl Rest when mixer is on.
• Do not use Bowl Rest on small (1.5quart) mixing bowls or plastic mixing bowls.
Shift and Stir™ Bowl Lever Use the lever to move the turntable. This allows you to position the beaters
near the edge of the bowl or in the center.
USING YOUR MIXER
1.Always make sure mixer is unplugged and speed control is set on OFF. Insert beaters. Use as hand
mixer or assemble on stand.
2. Plug mixer into electrical outlet.
3.Move the speed control to desired speed, starting at 1 and increasing to a higher speed as necessary.
4. If using as a stand mixer do not leave mixer unattended. Always monitor the progress of the mixing.
Using Your Mixer (continued)
When finished mixing, move the speed control to OFF and unplug mixer.
6.To eject beaters, push straight down on the speed control.
7.To remove mixer from stand, hold mixer and press mixer release button.Pull mixer to release from
stand.
P-4