battistella VAPORINO INOX MAX Manual De Instrucciones Y Normas De Uso página 13

6. IRONING OPERATION
1. Run the iron on garments, pressing the micro-switch of the iron at intervals (fig. 4) so
that steam comes out.
2. For delicate, blue or black garments, we suggest to use the specific anti-sheen shoe.
3. During ironing operation, always put the iron on its rubber rest (fig. 1).
4. For dry ironing it is possible to adjust the thermostat (fig. 3) on different positions
according to the type of fabric (look at garment label). For steam ironing set the
thermostat on "cotton" or "linen" (N.B.: the thermostat of TULIPANO irons must be
set between "wool" and "cotton").
5. When VAPORINO INOX MAXI is used with a non-vacuum board, some circular
water spots might form. In this case, reduce the steam flux through the hand-
wheel for steam regulation (fig. 2). It is recommended to combine the machine
with a vacuum and heated ironing board.
THERMOSTAT
7. WATER FILLING
When the water in the boiler is over, the lamp "no water" (fig. 2 D) switches on. At this
point disconnect the plug, rotate the valve plug (fig. 1) of 360° and wait for steam to go
out completely (the manometer has to indicate 0 bar). Unscrew the valve plug with care
and wait 5/10 minutes.
Then fill the boiler up to the desired level (fig. 2) paying attention not to overfill the water
on it (see section 4 point 1). Screw the safety valve plug again, connect the plug and wait
for the boiler lamp to switch off (fig. 2 C). Now the iron is ready again.
While refilling the boiler, do not spill water onto the machine. In the event this should
happen, dry immediately in order to avoid electrical risks.
8. BOILER DISCHARGE
Empty the boiler periodically. Carry out this operation when the VAPORINO INOX MAXI is
turned off, cold (the manometer has to mark 0 BAR ) and the plug disconnected. Wait t
least 1 hour after the switching off. During this procedure, wear proper gloves in order
to avoid accidental burns.
Vaporino Inox Maxi mod. 2016
Fig. 3
ELECTRIC
WIRE
STEAM
HOSE
12
MICROSWITCH
FOR IRON
Fig. 4
2016