Thomasville SPLS-LABK-TV Instrucciones De Montaje página 11

IMPORTANT NOTICE PLEASE READ
The following steps are only for those who wish to combine two
bookcases vertically. If you have bought only one bookcase or
bought two bookcases and plan to use them separately, disregard
the following steps.
on the top panel.
NOTE: The mending plates provided an important safeguard against accidents. Make sure you attach
the provided mending plates to the units with the screws to prevent the units from falling over. If you
buy more than one unit, the stacking configuration can be available. Or you can arrange the multiple
bookcases side-by-side to create a larger storage area.
12. Repeat the same procedure to form two sections: Base and Hutch. DO NOT install the bottom supports
(H) to the Hutch.
13. Now ask for assistance from another adult to stack the assemble Hutch onto the base properly. Make
sure its center and side edges are flush with each other.
14. Using the mending plate (9) as a template, mark the mounting hole locations at the center side of the
adjacent panels (A and D), as shown. With an electric dill and 1/16" drill bit (not included), carefully
drill into the marked location about 1/2" deep. Make sure you do not crack the side edges.
15. To secure the bookcases into place, attach the mending plates (9) over the drilled holes using the 12mm
screws (6) provided. Tighten with a Phillips screwdriver to secure.
Optional Stacking Configuration
9
6
Maximum weight 22.7 kg / 50 lb. for each shelf. Never place items
11