Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
USE
1. Connect the connection hose (2 meters) to the compressed air source.
2. Pull the hose out of the device to the required length. After every click, the retraction lock is
activated and the hose can be carefully released.
ROLL UP
1. Carefully pull the hose to unlock the retraction lock and then take the hose to the device.
2. Before disconnecting the hose from the compressed air supply, shut off the compressed air
supply and release the pressure in the hose using a compressed air device.
MAINTENANCE / CLEANING
Disconnect the connection hose (2 meters) from the compressed air source and reduce the
•
pressure in the hose if the product is not in use for a long period of time.
The roll-up system is maintenance-free and must not be cleaned with water on the inside.
•
Only clean the housing with a damp cloth.
•
EXPLODED VIEW
1 Inlet hose connector
2 Face cover
3 Handle
4 Guide washer
5 Bracket
6 Pivot
7 Lock pin
ENVIRONMENTAL PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All packaging
materials should be sorted, taken to a recycling centre and disposed of in a manner which
is compatible with the environment. Contact your local solid waste authority for recycling
information. Dispose of this product at the end of its working life environmentally.
SW-Stahl und Werkzeugvertriebs GmbH
5
d i e
8 Right drum
9 Outlet hose connector
10 Left drum
11 Drum cover
12 Centre shaft
13 Spring cover
14 Left & Right case
6
e
s
s
a r t S
h
c
s
m
e
R
Tel. +49 (0) 2191 / 46438-0
r e
F
ax +49 (0) 2191 / 46438-40
s
u
k r e
v
e
7
9
8
2
4 -
D
e
15 Left & Right panel
16 Spring holder
17 Hose
18 Roller
19 Spring
20 Belt
21 Stop ball
L
d . l h
a t s
w
s
@
o f n i
: l i
Publicidad
Tabla de contenido
