Mainstays MS17-D1-1011-01 Manual De Instrucciones página 6

NOTE: Please do not fully tighten all bolts until you finish assembling all parts. Once assembled, go back
and fully tighten all bolts. This will make it easier during assembly of unit.
1. Unpack the unit and confirm that you have all the hardware and required parts. Assemble the unit on a
carpeted floor or the empty carton to avoid any scratch.
2. Securely screw the Cam Bolts (2) into the designated small holes on the Bottom Panel (B) and the Side
Panels (C and D) using a Phillips screwdriver.
Assembly Instructions
D
C
B
6
2
②
10
×