Standard Accessories - Promaker PRO-TP550 Manual De Usuario

INSTRUCTIONS FOR SAFE HANDLING
1. Make sure that the tool is only connected to the voltage marked on the name plate.
2. Never use the tool if its cover or any bolts are missing. If the cover or bolts have been removed, replace
them prior to use. Maintain all parts in good working order.
3. Always secure tools when working in elevated positions.
4. Never touch the blade, drill bit, grinding wheel or other moving parts during use.
5. Never start a tool when its rotating component is in contact with the workpiece.
6. Never lay a tool down before its moving parts have come to a complete stop.
7. ACCESSORIES: The use of accessories or attachments other than those recommended in these
instructions might present a hazard.
8. REPLACEMENT PARTS: When servicing use only identical replacement parts.
DESCRIPTION
1. Drill chuck
2. Switch
3. Lock button
4. Reversing lever
5. Hammer shifting knob
6. Adjustment stopper
7. Aux. handle
8. Chuck key
9. Drill bit
10. Speed control dial
SPECIFICATIONS
Voltage: 120 V ~ 60 Hz
Input power: 550 W
No lsad speed: 0- 3000pm
Chuck size: 13 mm
Diling capacity:
Steel: 13 mm
Concrete: 13 mm
Wood: 25 mm

STANDARD ACCESSORIES

Aux. handle, Adjustment stopper, Chuck key
APPLICATIONS
(Use only for the purposes listed below.)
1. Drilling wood, metal and resin boards.
2. Drilling concrete (hammer drill only).
MOUNTING OF BIT (Fig. 1)
When mounting the drill bit (9), insert the bit into chuck (1) as far as it will go and tighten securely using the
chuck key (8) provided. There are three holes into which the chuck key should be inserted. Tighten each one
equally in turn.
The bit can be removed by following the above method in reverse.
4