Use; Power Adjustment - EQUATION MANNU Guía Del Usuario Y Manual De Mantenimiento

Set temperature adjustment
• Press , the screen displays "set"
• Adjust the desired temperature using
the buttons and
• Press to get out of the
adjustment cycle
• After a minute without actions, the
output is automatic

USE

Press for at least 2 seconds to turn on or turn off the stove
The behavior of the stove depends on the selected mode (see installation manual):
Event
Manual ignition
or start of a programmed period
The room temperature exceeds
the set temperature.
The room temperature drops below
the set temperature.
Manual stop
or end of a programmed period
The display indicates the different operating phases :
Ignition sequence
The spark plug is being
preheated.
The endless screw
loads the pellets, the
spark plug is heating
The stove is in the
stabilization phase,
the spark plug turns
off and the endless
screw loads the pellets
if necessary.
The stove is running,
the number indicates
the power.
The stove has reached
the set temperature
and switches 1
to maintain this
temperature.
The stove has reached
the set temperature
and is starting the
shutdown sequence.

Power adjustment

• Press
• Adjust the desired power using the
• Press
• After a minute without actions, the
Behavior in Eco mode
Initiation of the ignition sequence
The stove gradually lowers to power 1
The power increases up to the set value
Initiation of shutdown sequence
(cool down then shutdown)
51
, the screen displays "pot"
buttons and
to get out of the
adjustment cycle
output is automatic
Silent mode is activated when the stove is at power "1".
The room air fan turns off.
Behavior in Eco Stop mode
Initiation of the ignition sequence
The stove gradually lowers to power 1 then stop
Initiation of the ignition sequence
Initiation of shutdown sequence
(cool down then shutdown)
Shutdown sequence
The stove is in the
cooling phase, the
smoke extractor is at
maximum speed.
The stove is in the
brazier cleaning
phase, the smoke
extractor is at
maximum speed.
Is displayed in the
event of an ignition
attempt during a
cooling cycle. Wait
for the end of cooling,
clean the brazier, and
light again.
The stove is turned off
to reach the set power
EN