Step 3: Connecting The Antenna And The Receiver; Step 4: Fine Tuning And Fixing The Bracket - Strong SlimSat SA61 Manual Del Usuario

3.3 Step 3: Connecting the antenna and the receiver

Once you have installed the antenna in an open loop space and mounted the way you want it to be
the next step is to connect it all together.
In order to be able to watch your favourite satellite programmes, you need to connect your satellite
antenna to a receiver by a cable.
The cable between the antenna and the satellite receiver should not exceed 30 m as it will decrease
the quality of the signal.
The use of a long or bad quality cable and not isolated jacks can cause a loss of the signal level,
it would be preferable to use an RG6 Coaxial cable (HF 17VATC or 19VATC cable), in order to
minimise a signal loss.
How to prepare the cable?
It is important that the coaxial cable does not get damaged or kinked during the installation procedure.
3.4 Step 4: Fine tuning and fixing the bracket
Once fine tuning for signal reception is completed, please tighten all bolts and nuts.
6
Connector cover
F-connector
How to connect the cable to the antenna and the
receiver?
One side
to Antenna
Cable
PART 1 • English
Wall
Other side
to Receiver